The B6 Race Car Seat
The standard B6 is also
available in an XL size which is 30 mm wider. Unlike the new B6 XL Screamer,
the lighter B6 XL is not an FIA homologated model, but it is still ultra-rigid.
An externally narrower version is available named the B6-43 XL, with the edges
specially cut to reduce the outer width and allow a larger 100 kg + driver to sit
in a ultra-narrow car. When the outer edge is left on with the B6-47 XL, it
creates a continuous rolled edge around the whole perimeter of the seat.
The mounting points for the
B6 XL are on the underside of the seat as standard. With bottom mountings, the
TR1 Tillett adjustment runners can be attached underneath the seat using the
TK5 fitting kit. By using at least 40 mm of spacers under each M8 mounting
point, the B6 XL can be bolted directly to the floor without runners. The
Tillett 51 mm diameter x 5 mm thick Nylon spacers can be used for this purpose
and they enable some adjustment of angle.
The B6 XL is bottom mounted
as standard. As a no cost option, the B6 XL can also be ordered with side
mounts. When fitted with the side mount option the seat can use the same
bracket types as the B6 XL Screamer. Please specify either "bottom” or
"side mounts” when ordering.
The B6 XL is available in a
Carbon or black GRP finish to the front surface and comes complete with a suede
padded headrest as standard. To give it that extra bit of comfort, the B6 XL
has the option of Dinamica® covered suede padded panels. The weight of a B6 XL
is from 4.2 kg or 5.2 kg with suede covered panels.
No recommended products at the moment.